Installing the NOVSIGHT HALO Series ACC system enhances your vehicle’s lighting with customizable daytime running lights (DRLs) and synchronized main beam control. This guide provides a clear, step-by-step installation process to ensure proper functionality and safety.
🔧 Tools & Preparation
Before starting, gather the following:
- NOVSIGHT HALO Series ACC wiring harness
- Vehicle-specific connector cable (check compatibility)
- Basic tools (wire strippers, electrical tape, multimeter)
- Vehicle owner’s manual (for wiring reference)
⚠️ Safety First: Disconnect the battery negative terminal before wiring to prevent short circuits.
🔌 Step 1: Power Connections
- Red wire → Connect to the positive terminal (12V power source).
- Black wire → Connect to the negative terminal (ground).
✅ Verification: Use a multimeter to confirm stable power before proceeding.
🚗 Step 2: Locate Vehicle Wiring Control Center
- Open the vehicle’s wiring control center (location varies; consult your manual).
- Identify the daytime running light (DRL) control interface.
- Use a vehicle-specific adapter for a secure connection.
📌 Pro Tip: Label wires to avoid confusion during reassembly.
⚡ Step 3: ACC Wiring Guide
| Wire Color | Function | Connection Point |
| Yellow | Controls amber DRLs | DRL control circuit |
| Blue | Controls white DRLs | DRL control circuit |
| Green | Controls main beam | ⚠️ Must connect to high beam control |
Testing Each Connection
- Connect the blue wire → Start the vehicle → White halo DRLs should activate.
- Connect the yellow wire → Restart → Amber halo DRLs should activate.
- Connect the green wire → Test high beams → Main beam should sync correctl.
🔄 System Behavior & Priority
- Manual Button Control: The harness button overrides ACC settings for instant adjustments.
- Automatic Mode: If no button is pressed, the halo lights sync with the vehicle’s DRLs (turn on/off with the ignition).
🚨 Troubleshooting Tips
❌ No Power?
- Check fuse connections.
- Verify proper grounding of the black wire.
❌ Lights Not Syncing?
- Ensure the green wire is connected to high beam control, not low beam.
- Recheck DRL circuit compatibility.
📌 Final Notes
- Consult your vehicle manual for exact wire locations.
- Secure all connections with electrical tape or heat shrink tubing.
- For advanced customization, refer to NOVSIGHT’s official documentation.
For more operation guidelines, please watch the video
Hinterlasse einen Kommentar
Alle Kommentare werden vor der Veröffentlichung geprüft.
Diese Website ist durch hCaptcha geschützt und es gelten die allgemeinen Geschäftsbedingungen und Datenschutzbestimmungen von hCaptcha.